This blog is written with the EN71-2014+A1:2018
The choke hazard of hard part toys with spherical ends is pretty big so its very important that your spherical toys are within the limits, whether that be for peg dolls so they are fished out of the mouth easily or as in this blog, for small balls and ovoids (eggs).

Spheres, balls, eggs, ovoids
The standards state that a ball is a ‘spherical,ovoid or ellipsoid object’ So many rounded objects could potentially fit this but the obvious ones are eggs and balls, squashed ball shapes would also come into this. If you aren’t sure, you can’t really go wrong with sticking to the template E rule.
Template E is 44.5mm in diameter, with a base its set on of 6.4mm tall
its a circle hole shape template and balls and eggs should be dropped in, If they pass through the template completely then they are not suitable for under 3s, and should carry a warning. However, as always you should be very conscious of what you are adding a warning to – because if your toy as a completed item or set is appealing to under 3s, then its time for a redesign(check out our toy appeal blog to see what the age determination guidelines thinks)
A solid half sphere is rather oddly not counted in this due to the flat edge, and instead just goes by the small parts cylinder, which if it passes is okay from 10 months upwards/from when a child is sitting.
Baby toys with spherical ends
If you are looking to be making baby toys (for under 10 months/not sitting) such as rattles with spherical ends, you will need to use template B (same as for peg dolls) to ensure the ball shape end does not poke out of the end of the template at all.
Dangling balls
When it comes to balls on cords (string, ribbon, etc) its a whole new territory of complication. The dangling bead/ball must be put through the template as far as the toy allows, and must not protrude through the template from the template top, to the midway point of the ‘ball’, more than 3cm. If you are unsure, a lab can provide this test for you.
They also need to pass all the other hard part tests such as impact, tension tests, drop tests, soak tests etc which are outlined in our wooden toy add on to our guide.
Hollow Hemispheres(cup shaped toys)
Toys that might need to comply with this would be things like hollow eggs, nesting toys, nesting dolls.
Due to the vacuum aspect of a cup shape toy (hollow egg, cup, bowl shape) its really important that it has ventilation holes if its within a certain size. Any cup shape toy with a round,oval or elliptical inner opening between 62-102mm with a depth greater than 13mm must comply with this.
There’s a few different options you can go with:
1. Adding 2 or more 2mm wide holes, 13mm or more measured from the outside rim, they must be at least 13mm apart. If they are put in the base, thats great, but to put them in the side you’ll need a protractor to make sure they are at least 30degrees to 150 degrees apart but no more.
2. adding a divider midway through the toy from less than 6mm from the rim
3. having a scalloped edge with peaks of 25mm and depths of 6mm
4. Have 3 holes 6mm -13mm from the rim and 100 or more degrees (on a protractor, looking down on the opening) apart.
Hopefully this sets you on the way to sorting out your rounded toys!
